JMV Fire Security Systems

The TX7100 intelligent addressable optical smoke detector is the ideal device for most applications, due to its spiffing linear response to a wide variety of different types of smoke patterns. Secure and speedy communication through the on-board processor enables the detector to make its own decision, resulting in greater automation. In the event of fire, the integral microprocessor analyses the signal according to factors such as signal strength and rate of increase, then confirms these patterns with the pre- programmed fire scenarios and smoke patterns, for a faster and safer response. Once it is confirmed, the LED indicates the sensor status and parallel sending communication signal to the control panel. The TX7100 detector is compatible to the TX7004 analogue intelligent fire alarm control panel, produced by single manufacture T&A, to avoid addressable communication compatibility problem.

TX7130 Conventional Reflective Beam Detector has built in Laser beam pointing and Digital guide display for real user friendly alignment method. The Laser beam pointing accurately point the exact location where to mount mirror and with additional digital guide display allows to monitor and guide on the actual light intensity between the mirror and detector which cannot be seen by our naked eye making it more easy and convenient in alignment commissioning.
The TX7130 has four adjustable operational ranges of between 8 to 20, 20 to 40, 40 to 70 and 70 to 100 meters beside with three adjustable sensitivity setting ranges from 2.6dB, 3.8dB and 5.8dB to meet the specific environmental requirement. The TX7130 works on the principle of reflective infrared beam obscuration. Used in conjunction with a reflector, it will notify the fire alarm panel when the infrared beam is obscured by smoke  

The TX7004 intelligent addressable fire alarm control panel comprise of a range of analogue addressable, microprocessor based fire alarm control equipment to offer flexibility in both design and operation. The System is modular concept for easy tailoring of system design, to meet the full requirements of the project. The TX7004 intelligent addressable fire alarm control panel is designed and manufactured to meet the requirement of BS EN54 Part 2&4.
The TX7004 intelligent addressable fire alarm control panel is designed to provide early warning fire detection, to quickly identify the location of fire and provide user definable text informing the occupants of the building of potential smoke spread. Simultaneously, the TX7004 will alert and evacuate the occupants, and control all necessary auxiliary command functions such as 

elevator control, air handling shut down, gas shut off & damper control, as per the cause and effects requirements configured though Command Builder Set-up.

The TX7140 Addressable Manual Call point use a non-breakable glass which is designed to press under light pressure triggering the call point into an alarm condition, with LED indicator mounted onto the front face to simplify the location of an operated call point. Safe to press and no hammer is required. The protected flap on the lower part is used for reset through supplied special tool.

The TX7300 Addressable Sounder and Strobe is alarm warning device used to notify persons in the vicinity of the occurrence fire emergency in order the person to take appropriate measures. The unit adopt multi- application device starting from the types, parameters and wiring layout in single unit. The TX7300 addressable sounder and strobe can change into different alarm warning types such as sounder-strobe type, sounder type or strobe type using programming tool. In addition, parameters can be configured according to the requirement which include alarm tone from 17 different tones, single address or dual address mode and also setting of power mode to low current consumption in a simple programming.

OverviewThe NC7004 is multiple communication protocols such a USB, Ethernet, Can Bus, RS485/RS232 on a single card intended to use in TX7 series control and indicating equipment. These four protocols synchronously working separately, the USB port is used for programing the control panel by uploading the data base form the laptop and for interfacing the Graphic Monitor Center (TX7812) server and client machine, while the CAN Bus signal is for the networking that can support up to 512 control panel in one ring. The ethernet port is used for email notification or for an IP networking if required. The RS485/RS232 is use for interfacing third party system such as building management system.